Distinguishing single line and multi-line comments
I’m trying to set up UDL for Julia and I’m running into an issue with multi-line comments. The problem is that in Julia, single-line comments are delimited with a #, but multi-line comments are delimited with #= and =#, so whenever N++ sees a multi-line comment it just sees the # and assumes it’s a single-line comment and won’t highlight the remaining lines. Is there a way to get it to distinguish between the two types of comments? If I could use regex this would be easy, but apparently UDL does not support that at this time.
Unfortunately there are limitations in UDL. So with this one you are out of luck.
I know one workaround for this.
So to make colors work: in UDL you leave both “Comment line style” and “comment style” boxes empty.
Then go to “operators and delimiters” tab and first define multiline comment delimiters,
Open: #= Close: =#.
Then (it must be defined after multiline delimiters) you define single line comment:
Open: # Close: ((EOL))
Now the colors should work.
After that you’ll need commands to comment/uncomment selections.
This can be done via Pythonscript plugin.
Actually it might be done just with Regex replace but I prefer scripting solution.
By scripting the idea is to define small scripts that work on selected text and insert # or #= where needed. If you know Python this should be easy to do.
With Regex only this should work also but I am no expert in Regex.
Indeed, @Claudia-Frank is right here - for this case it is better only to define line-comment by delimiters, and multi-line leave in the comments definition. This way only line comment will need a new command.
Thank you very much! This is an adequate solution.