Writing G-code and want to get automatic "comments" or descriptions of a command.

  • Hello!

    I’m dissecting a lot of G-code to find out what each line of code means and i do have a PDF sheet with all of the codes explained. But this is awfully time consuming and sometimes problematic.

    I was wondering if there is a way that i could copy-paste the code in to Npp and get the definitions of code as a bracketed comment next to the line of code?

    It seams, it would be easier to just make a “translation” file once and then have all the code translated on the fly.

    Has anyone had contact with such a problem? :)


  • There is probably a way.
    if you provide a sample G-code and pdf file with transcript. And the text from this pdf is better.
    mail: trdmval@gmail.com

Log in to reply